Return to site

A Guide on What You Need to Know about the 2 Shot Overmolding Process

The process of injecting any substance into the substrate that had already been injection molding is known as overmolding. It is very important for you to consider this method as very useful in a number of production processes. The advantage of using this method is that it is going to help you to get electronics that have superior abrasion and in addition to that, higher levels of chemical resistance. There are also other advantages for example, the higher levels of biocompatibility that you will be able to get from the use of this method. This method is done through a number of processes that have to be checked properly. This kind of molding is only possible when there is both low-pressure molding and conventional injection molding which are both processes that are considered to be important in the molding process. The completion of this project will be done by injection overmolding but before that, you have to do they low-pressure molding so that you can begin the process of getting the molded device. High pressure injection molding is effective for helping you to seal and also protect the product is something that is much stronger as the outer layer.

It is through the application of this method that quite a number of medical and consumer electronics are made. It is important for you to understand that all of these processes usually have been properly checked when you work with the right companies. What you will notice is that the company will always insist on having a very thorough analysis process to ensure that you have been able to remove trapped air and in addition to that, other kinds of issues that can bring a lot of problems in the final results that you be getting. The overmolding process is usually get through the analysis process that is going to check the heat and pressure distribution. Ensuring that the electronics have been properly set is very important and that is why the injection molding process is also done under an analysis system that has been put in place. Get more info.

When you work with the best experts, you’ll also be able to get the use of the injection molding process of the use of the right materials. Your also be able to get good adhesion levels when the materials are carefully selected and that is why you need the right people. It is good for you to work with the right experts if you are going to do overmolding. Learn more details about the importance of mold inspection, visit

All Posts

Almost done…

We just sent you an email. Please click the link in the email to confirm your subscription!

OKSubscriptions powered by Strikingly